Evertz Microsystems X-Series 12x2 HD/SD SDI Video Router with Bypass Relay & SoftSwitch Capability
with Bypass Relay & SoftSwitch Capability
Product Highlights:
- Bypass verification test using main menu
- Programmable tally output bus
- GVG TEN-XL protocol and Quartz protocol are supported
- Embedded SoftSwitch provides clean video
- Video and audio input relay bypass for power failure bypass protection
- Optional dual power configuration
- Remote control via SNMP
- Comes with a blank front panel
**SPECIAL ORDER.
NO RETURNS**
Evertz Microsystems X-Series 12x2 HD/SD SDI Video Router with Bypass Relay & SoftSwitch Capability
Evertz Microsystems X-Series 12x2 HD/SD SDI Video Router with Bypass Relay & SoftSwitch Capability
The X-Series 12x2 Video Router from Evertz Microsystems supports SMPTE 424M (3 GB/s), SMPTE 292-1 (1.5 GB/s), SMPTE 259 (270, 360, or 540 MB/s), and DVB-ASI video signals. It features the ability for redundancy protection with a bypass relay and optional dual power supplies. The router comes equipped with an embedded SoftSwitch for all four audio groups. The embedded audio on the two video busses uses SoftSwitch technology to eliminate audible pops when switches are performed for SD, HD, or 3G videos. Housed in a 1 RU rackmount frame, the unit can be used with a rackmount remote control panel (available separately) that replaces the built-in control panel. The unit can also be controlled by Quartz over Ethernet, contact closures on the GPI control port, or through the RS-232 or RS-422 serial remote control port using industry-standard switcher protocols.
| Video Input |
|---|
| Standard |
SMPTE ST 424-1 (3 GB/s), SMPTE ST 292-1 (1.5 GB/s), SMPTE ST 259 (270, 360, or 540 MB/s), and DVB-ASI |
| Number of Inputs |
12 |
| Connector Type |
BNC per IEC 61169-8 Annex A |
| Equalization |
Automatic:
Up to 492.1' (150 m) at 3G, 902.2' (275 m) at HD, 1558.4' (475 m) at SD
With Bypass Output:
377.3' (115 m) at 3G, 656.2' (200 m) at HD, 1476.4' (450 m) at SD |
| Input Range |
Measured with respect to the Genlock reference
±1/2 line when Coarse phase = 1, Fine phase = 0 |
| Video Output |
|---|
| Standard |
SMPTE ST 424-1 (3 GB/s), SMPTE ST 292-1 (1.5 GB/s), SMPTE ST 259 (270, 360, or 540 MB/s), and DVB-ASI |
| Number of Outputs |
2 per buss, 2 busses; Inputs 1 and 12 bypass protected |
| Connector Type |
BNC per IEC 61169-8 Annex A |
| Signal Level |
800 mV nominal |
| DC Offset |
±0.5 V |
| Phase |
Measured with respect to the Genlock reference
Adjustable 1 line to a full frame of delay – set by Coarse phase parameter. The active video content will align to the nearest line |
| Video Reference |
|---|
| Type |
Menu selectable – depends on video format |
| Connectors |
2 x BNC per IEC 61169-8 Annex A |
| Termination |
High impedance loop through |
| GPI Control Port |
|---|
| Number of Inputs |
14 opto-isolated, programmable functions |
| Number of Outputs |
4 sets of relay contacts, normally closed, programmable functions |
| Relay Rating |
Maximum: 1 A at 30 VDC |
| Control Port |
|---|
| Protocol |
Remote control panel |
| Standard |
RS-422 |
| Baud Rate |
9600 |
| Connector |
9-pin female "D" |
| Serial Interface |
|---|
| Protocol |
GVG Ten XL Protocol, master, slave or quartz router protocol |
| Standard |
RS-232 or RS-422 |
| Baud Rate |
Programmable |
| Connector |
9-pin female "D" |
| Ethernet |
|---|
| Connector |
RJ45 |
| Protocol |
Quartz router protocol, SNMP |
| Electrical |
|---|
| Power |
Auto ranging 100 to 240 VAC, 50/60 Hz 40 W |
| Fuse |
250 V, 1 A time delay |
| Physical |
|---|
| Dimensions |
1.75 x 19 x 7.75" (45 x 483 x 196 mm) |
| Weight |
8 lb (3.5 kg) |
